1. General

No: 694270000149

Date(g): 22/7/2019 | Date(h): 20/11/1440

Status: In-Force

Effective from 2019-07-22 - Jul 21 2019
To view other versions open the versions tab on the right

The ATM will have a pin-hole camera located above the client facing screen to record the client's face, this will be supported by an overhead camera to record the transaction and whether cash was deposited and withdrawn. Additionally, in the case of an off-site ATM and additional camera is to be located to observe and cover rear entrance to the cash service room as well as an internal camera to observe the custodians/financial organisation employees during their activities inside the service room. Supporting CCTV equipment shall be installed in lockable racks or cabinets in secure rooms, in accordance with the branch security zoning policy.

Note: This section must be read along with Security Surveillance Systems, from pages 2-16, as the primary resource and means to support and clarify the surveillance requirements.

Camera Description
1.	The specified unit shall be of manufacturer's official product line, designed for commercial and/or industrial 24/7/365 use.
2.	The specified unit shall be based upon standard components and proven technology using open and published protocols
3.	The specified unit shall be manufactured in accordance with ISO 14001.

Certifications and Standards

General abbreviations and acronyms:

	1.	AGC: Automatic gain control
	2.	AES: Advanced Encryption Standard
	3.	API: Application Programming Interface
	4.	Aspect ratio: A ratio of width to height in images
	5.	Bit Rate: The number of bits/time unit sent over a network
	6.	Bonjour: Enables automatic discovery of computers, devices, and services on IP networks.
	7.	DHCP: Dynamic Host Configuration Protocol
	8.	DNS: Domain Name System
	9.	EIS: Electronic Image Stabilization
	10.	FPS: Frames per Second
	11.	FTP: File Transfer Protocol
	12.	H.264 (Video Compression Format)
	13.	IEEE 802.1x: Authentication framework for network devices
	14.	IP: Internet Protocol
	15.	IR light: Infrared light
	16.	ISO: International Standards Organization
	17.	JPEG: Joint Photographic Experts Group (image format)
	18.	LAN: Local Area Network
	19.	LED: Light Emitting Diode
	20.	LPR: License Plate Recognition
	21.	Lux: A standard unit of illumination measurement
	22.	MBR: Maximum Bit Rate
	23.	MPEG: Moving Picture Experts Group
	24.	Multicast: Communication between a single sender and multiple receivers on a network
	25.	NTP: Network Time Protocol
	26.	NTSC: National Television System Committee - a colour encoding system based on 60Hz
	27.	ONVIF: Global standard for the interface of IP-based physical security products
	28.	PACS: Physical Access Control System
	29.	PAL: Phase Alternating Line - a colour encoding system based on 50Hz
	30.	PoE: Power over Ethernet (IEEE 802.3af/at) standard for providing power over network cable
	31.	Progressive scan: An image scanning technology which scans the entire picture
	32.	PTZ: Pan/Tilt/Zoom
	33.	QoS: Quality of Service
	34.	RAID: Redundant Array of Independent Disks
	35.	SaaS: Software as a Service
	36.	SIP: Session Initiation Protocol
	37.	SMTP: Simple Mail Transfer Protocol
	38.	SMPTE: Society of Motion Picture and Television Engineers
	39.	SNMP: Simple Network Management Protocol
	40.	SSL: Secure Sockets Layer
	41.	TCP: Transmission Control Protocol
	42.	TLS: Transport Layer Security
	43.	Unicast: Communication between a single sender and single receiver on a network
	44.	UPnP: Universal Plug and Play
	45.	UPS: Uninterruptible Power Supply
	46.	VBR: Variable Bit Rate
	47.	VMS: Video Management System
	48.	WDR: Wide dynamic range
The specified unit shall carry the following EMC approvals:
	1.	EN 55032 Class A, EN 55024, EN 61000-6-1, EN 61000-6-2
	2.	FCC Part 15 - Subpart B Class A
	3.	VCCI Class A
	4.	RCM AS/NZS CISPR 32 Class A
	5.	ICES-003 Class A
	6.	KCC KN32 Class A, KN35
The specified unit shall meet the following product safety standards:
	1.	IEC/EN/UL 60950-1
	2.	G. The specified unit shall meet relevant parts of the following video standards:
	3.	SMPTE 296M (HDTV 720p)
	4.	SMPTE 274M (HDTV 1080p)
	5.	SMPTE ST 2036-1 (UHDTV)
The specified unit shall meet the following standards
	1.	MPEG-4:
		a.	ISO/IEC 14496-10 Advanced Video Coding (H.264)
	2.	Networking:
		a.	IEEE 802.3at (Power over Ethernet Plus)
		b.	IEEE 802.1X (Authentication)
		c.	IPv4 (RFC 791)
		d.	IPv6 (RFC 2460)
		e.	QoS - DiffServ (RFC 2475)

Quality Assurance

A.	All installation, configuration, setup, program and related work shall be performed by electronic technicians thoroughly trained by the manufacturer in the installation and service of the equipment provided.
B.	The contractor or designated sub-contractor shall submit credentials of completed manufacturer certification, verified by a third-party organization, as proof of the knowledge.
C.	The Contractor shall provide four (4) current references from clients with systems of similar scope and complexity that became operational in the past three (3) years. At least three (3) of the references shall be utilizing the same system components, in a similar configuration as the proposed system
D.	The specified unit shall be manufactured in accordance with ISO 9001.

Warranty

A.	All security system components and labour furnished by the contractor including wiring, software, hardware and custom parts shall be fully warranted for parts, materials, labour and travel expenses for a minimum of three (3) years from date of the final acceptance of the Video Surveillance System.
B.	The manufacturer shall provide warranty and optional extended warranty for the camera for a total period of maximum five years. If enacted as part of the contract, the contractor will repair or replace parts and/or labour per the warranty for the length of this warranty at no cost to the client.

Soft Launch